Industry Information

Update June 05, 2022

MuCell microporous injection moulding process

Trexel Corporation in the United States based on MIT microcellular foaming concept, the microcellular foaming technology has been industrialized, and has been applied in injection molding, extrusion...

Update June 02, 2022

Injection molding process analysis about UPVC plastic raw material

PVC, also known as hard PVC, is an amorphous thermoplastic resin made by polymerizing vinyl chloride monomers plus certain additives (such as stabilizers, lubricants, fillers, etc.). In addition to...

Update June 01, 2022

Advantages of Nozzle Pressure Measurement during injection molding

Advantages of Nozzle Pressure Measurement The above has demonstrated the importance of pressure regulation during injection and holding pressure. Therefore, the accuracy and repeatability of pressure...

Update May 31, 2022

All-Electronic Press Force Measurement during injection molding

All-Electronic Press Force Measurement Since the all-electric injection molding machine does not have a vector fluid that causes motion, hydraulic pressure detection cannot be performed. Therefore,...

Update May 30, 2022

Screw speed during injection molding

Hydraulic equipment and discharge volume and pressure adjustment The centrifugal pump produces an average hydraulic pressure of up to 140 bar, which is particularly suitable for injection molding. In...

Update May 28, 2022

Injection speed control during injection moulding

Injection speed control includes open-loop control, closed-loop control and closed-loop control options. Open-loop systems rely on shared proportional valves. Proportional tension is applied to the...

Update May 27, 2022

Screws and solenoid valves for injection moulding

On full voltage machines, all movements are performed by brushless synchronous motors equipped with permanent magnets. Rotary motion is converted into linear motion through ball bearing screws that...

Update May 26, 2022

Pressure adjustment during injection molding

Whether it is a hydraulic or electric injection machine, all the movements in the injection molding process will generate pressure. Appropriate control of the required pressure can produce a finished...

Update May 25, 2022

PET preform injection molding system with vertical clamping device

Hot filling poses extreme requirements in terms of errors for PET preforms. Due to crystallization, particularly high precision is required during the production of hot-filled preforms, especially at...

Update May 21, 2022

vertical clamping device

PET preform injection molding system with vertical clamping device Hot filling of beverages places particularly high demands on the quality of PET preforms. The vertical technology used by...